Inbound Rule Configurations; Table 64: Inbound Rule Configuration Parameters - Grandstream Networks UCM6510 User Manual


Click on to edit the inbound route.

Click on to delete the inbound route.

INBOUND RULE CONFIGURATIONS

Trunks
DID Pattern
Prepend Trunk Name
Alert-Info
Inbound Multiple Mode
Default Destination
Firmware Version 1.0.10.39

Table 64: Inbound Rule Configuration Parameters

Select the trunk to configure the inbound rule.

All patterns are prefixed with the "_".

Special characters:
X: Any Digit from 0-9.
Z: Any Digit from 1-9.
N: Any Digit from 2-9.
".": Wildcard. Match one or more characters.
"!": Wildcard. Match zero or more characters immediately.
Example: [12345-9] - Any digit from 1 to 9.

The pattern can be composed of two parts, divided by a '/' character.
The first part is used to specify the dialed number the second part is
used to specify the caller ID and it is optional, if set it means only the
extension with the specific caller ID is allowed to call in or call out.
For example, patter '_2XXX/1234' means the only extension with the
caller ID '1234' is allowed to use this rule.
If enabled, the trunk name will be added to the caller id name as the
displayed caller id name.
Configure the Alert-Info, when UCM6510 receives an INVITE request, the
Alert-Info header field specifies an alternative ring tone to the UAS.
Multiple mode allows user to switch between destinations of the inbound
rule by feature codes. Configure related feature codes in the "Feature
Codes" page. If this option is enabled, user can use feature code to switch
between different destinations.
Select the default destination for the inbound call.

Extension

Voicemail

Conference Room

Call Queue

Ring Group

Paging/Intercom

Voicemail Group
UCM6510 IP PBX User Manual Page 192 of 339