System Parameter And Data Lists (Smc Lists); Memory All Clear (Sp2-18) - Ricoh G035 Service Manual

No. Description
67 Development Bias
68 Not used
69 Transfer Belt Bias
70 ID Sensor
71 ~ 74 Not used
75 Exhaust Fan Motor
76 Cooling Fan Motor
77 Not used
78 Cooling Fan Motor (Bridge Unit)
79 ~ 84 Not used
85 Not used
86 ~ 89 Not used
90 Laser Diode

4.2.6 SYSTEM PARAMETER AND DATA LISTS (SMC LISTS)

1. Access SP mode 2-22 and select the menu level 3 number corresponding to
the list that you wish to print.
2. Press the "Enter #" key to print the list.
3. Exit SP mode.

4.2.7 MEMORY ALL CLEAR (SP2-18)

NOTE: Memory All Clear mode resets all the settings stored in the NVRAM to their
default settings except the following:
• Electrical total counter value
• PM counter value
• Machine serial number
• Plug & Play Brand Name and Production Name Setting (SP2-21)
Among the settings that are reset are the correction data for process
control and all the software counters.
Normally, this SP mode should not be used. This procedure is
required only after replacing the NVRAM or when the copier
malfunctions due to a damaged NVRAM.
1. Print out all SMC Data Lists (SP mode 2-22).
2. Access SP mode 2-18.
3. Press the "Enter #" key twice.
4. Turn the main power switch off and back on.
5. Do the laser beam pitch adjustment.
SM
SERVICE PROGRAM MODE
No.
91 Not used
92 Shift Tray Lift Motor (Finishers)
Jogger Motor (3,000-sheet
93 Finisher)/Jogger Fence Motor
(1,000-sheet Finisher)
Stapler Motor (3,000-sheet
94
Finisher)
Stack Feed Out Motor
95
(Finishers)
96 Shift Motor (Finishers)
Stapler Rotation Motor (3,000-
97
sheet Finisher)
98 ~ 99 Not used
4-19
Description
G035