Ricoh G035 Service Manual page 173

Menu
Menu Menu
Level 2 Level 3
Polygon Motor
Off Timer
7
Development
Bias
Adjustment
8
(for ID sensor)
Transfer
Current
1 Correction
(By-pass feed
- a)
9
Transfer
Current
Correction
2
(By-pass feed
- b)
TD Sensor
Initial Setting
10
SM
Function
Input the time that the polygon motor
turns off after entering the stand-by
condition.
If set at "0", the polygon mirror motor
never turns off during stand-by.
However, when the machine goes into
energy saver mode, the polygon
mirror motor turns off regardless of
this timer.
Adjusts the development bias for
developing ID sensor pattern.
This can be adjusted as a temporary
measure if faint prints occur due to an
aging drum.
Adjusts the transfer current correction
coefficient that is used if the paper
width is less than 150 mm.
Adjusts the transfer current correction
coefficient that is used if the paper
width is less than 216 mm.
Performs the TD sensor initial setting.
This SP mode controls the voltage
applied to the TD sensor to make the
TD sensor output about 4.0 V. Press
"Enter #" to start. After finishing this,
the TD sensor output voltage is
displayed. E.g. 4.00 V
Use this mode only after changing
the TD sensor and developer, or
adding new developer.
4-9
SERVICE PROGRAM MODE
Settings
[Default]
0 ~ 60
5 seconds/step
[10 seconds]
200 ~ 700
10 V/step
[410 V]
1.0 ~ 3.0
0.1/step
[1.5]
1.0 ~ 3.0
0.1/step
[1.5]
Execute
G035