Ricoh G035 Service Manual page 161

G035I767.WMF
G035I512.WMF
8. Install the sensor bracket [A] (1 short stepped screw, 1 spring).
9. Connect the harnesses [B].
NOTE: 1) The harness binders [C] must not be between the harness clamps [D].
2) The harness binder [E] must be positioned to the left of the harness
clamp.
10. When a three-punch-hole unit is installed: Turn on switch 1 of DIP SW 100
on the finisher control board.
11. Slide the hopper [F] into the finisher.
12. Reassemble the finisher and attach the 3,000-sheet finisher to the copier, then
check the punch unit function.
SM
[E]
[A]
[F]
3-43
PUNCH UNIT INSTALLATION
[B]
[D]
G035I511.WMF
[C]
G035