Ricoh G035 Service Manual page 147

[G]
[D]
[F]
A697I550.WMF
7. If the customer requires the punch unit, install it now, before attaching the
finisher to the machine. See Punch Unit Installation.
8. Open the front door of the finisher, and remove the screw [A] that secures the
locking lever [B]. Then pull the locking lever.
9. Align the finisher on the joint brackets, and lock it in place by pushing the
locking lever.
NOTE: Before securing the locking lever, make sure that the top edges of the
finisher and the copier are parallel from front to rear as shown [C].
10. Secure the locking lever (1 screw) and close the front door.
11. Install the shift tray guide [D] on the shift tray. If the customer does not wish to
install it on the shift tray, store it at the location [E].
NOTE: The shift tray guide helps to properly stack exiting paper. However, it
reduces the capacity of the shift tray by 50, from 3000 to 2950.
12. Install the shift tray [F] (4 screws).
13. Connect the finisher cable [G] to the main machine.
14. Turn on the main power switch and check the finisher operation.
SM
3,000-SHEET FINISHER INSTALLATION (A697)
[C]
[B]
[A]
[E]
3-29
A697I534.WMF
G035