Drum - Ricoh G035 Service Manual

6.3.2 DRUM

[B]
[A]
G035R302.WMF
[F]
G035R304.WMF
1. Remove the PCU. (See PCU.)
2. Remove the toner cap [A] and put it over the toner entrance hole [B].
3. Turn the PCU upside-down. Then, remove the lower PCU cover [C] (2 screws,
3 pawls).
4. Push the drum [D] towards the front
releasing the charge roller [E] using the release lever
drum .
NOTE: Do not touch the drum surface with bare hands.
5. After replacing the charge roller, check the value of SP2-5-1. If it is not at the
standard value, change it to the standard value using SP2-5-1.
NOTE: If this is not done, the carrier will be attracted to the drum because the
charge roller voltage will be too high.
6. After replacing the drum, perform the ID sensor initial setting using SP2-14.
SM
[D]
[E]
(the left side in the illustration), while
6-7
PHOTOCONDUCTOR UNIT (PCU)
[C]
G035R303.WMF
[F]. Then, remove the
G035