Ricoh G035 Service Manual page 288

SERVICE CALL CONDITIONS
SC961: Printer Ready ID Error
⇒
Definition [B]
The IPU sends the Ready signal back to the engine software for printing the
next page, but the signal does not contain the correct response code to the
original command.
Possible Causes
• BICU Software defective
• BICU Board defective
SC962: Memory Setting ID Error
Definition [B]
The ID that is sent from the memory when the IPU sent the memory ready
signal is incorrect.
Possible Causes
• Software defective
SC963: Memory Finishing ID Error
Definition [B]
The ID that is sent from the memory when the IPU sent the memory finish
signal is incorrect.
Possible Causes
• Software defective
SC964: Printer ready error
Definition [B]
The print ready signal is not generated for more than 17 seconds after the IPU
received the print start signal.
Possible Causes
• Software defective
SC980: HDD Access Error
Definition [B]
Incorrect parameter sent to the HDD controller.
Possible Causes
• Software defective
• Poor connection between BICU and HDD.
G035 7-18
Rev. 09/2000
SM