Ricoh G035 Service Manual page 169

Service Program Access Procedure
Entering the Service Mode
1. Turn the machine on while pressing the [Online] key and [Escape] key together
until the service mode appears on the display.
2. Use the or key to scroll through the menu listing. To select an item, press
the [Enter] key. Then the sub menu will appear.
3. To return to the previous menu, press the [Escape] key.
Exiting the Service Mode
There are two ways to exit the service mode.
1. Turning off and on
1) Turn off the machine.
2) Wait for a few seconds and then turn it on again. The machine runs the
initializing mode then goes to ready.
2. [On Line] key
1) Press the [On line] key.
2) Wait a few seconds, The machine exits service mode automatically.
3) The printer starts to initialize.
Accessing the Required Program
Select each program level in sequence.
1. Scroll through the 1st level programs using the
"Enter #" key.
2. Scroll through the items in the next lowest level using the
back to a higher level, press the "Escape" key.
Inputting a Value or Setting for a Service Program
1. Enter the required program mode.
NOTE: The setting appearing initially on the display is the current setting.
2. Select the required setting using the
(decreasing), then press the "Enter" key.
NOTE: The previous value remains if the "Enter" key is not pressed.
3. Exit service mode.
SM
SERVICE PROGRAM MODE
or
key (increasing) or the
4-5
key. Then press the
or key. To go
key
G035