Printer Installation; Connecting The Interface Cables; Checking The Connection - Ricoh G035 Service Manual

PRINTER INSTALLATION

3.2 PRINTER INSTALLATION
Please refer to the Operating Instructions to install the main frame.

3.2.1 CONNECTING THE INTERFACE CABLES

Parallel Interface
An IEEE1284 compatible printer cable is required to connect the printer controller
to a host PC parallel port.
Network Interface
A STP (Shielded Twisted Pair) cable with RJ45 connectors is required to connect
the Network Interface Board to the computer network. (The cable should be
Category/Type 5 or better.) After hardware setup, the user should do the network
setup. The setup procedure is described in the NIB section.

3.2.2 CHECKING THE CONNECTION

Connection between Printer Controller (and Related Options; DRAM
SIMM, Hard Disk Drive), NIB and Engine
1. Plug in the power cord and turn on the main switch.
2. Enter the printer user mode.
1) Press the Menu key.
2) Press or
3. Print out the printer configuration page.
1) Press the "Enter #" key, and the LCD displays "Config. Page".
2) Press the "Enter #" key to print the configuration page. The machine
automatically prints the printer configuration page.
NOTE: For more detailed information about the operation panel settings, refer to
the operating instructions.
The printer configuration page is similar to that shown on the next page.
G035
key until LCD displays "List Print".
3-4 SM