Ricoh G035 Service Manual page 174

Menu
Menu Menu
Level 2 Level 3
TD Sensor
Manual
Setting - V
1
11
TD Sensor
2 Manual
Setting - V
Test Pattern
Printing
12 1
Process
Control
Setting -
Charge-a
1
13
Process
Control
Setting -
Charge-b
2
G035
Adjusts the TD sensor output (V
Change this value after replacing the
development unit with another one
TS
that already contains toner.
For example, when using a
development unit from another
machine for test purposes. To adjust
V , do the following.
TS
1. Check the value of SP2-11-1 in
both the machine containing the
test unit and the machine that you
are going to move it to.
2. Install the test development unit,
then input the V
SP2-11-1.
3. After the test, put back the old
development unit, and change
SP2-11-1 back to the original
value.
Adjusts the minimum value for SP2-
11-1.
TMIN
Prints the printer test patterns.
See section 4.2.3 for how to print test
patterns. Example: 10 Trimming area
pattern
This SP mode is useful for finding
whether the LDDR or the BICU is
defective. If the printout is not OK, the
LDDR is defective.
Adjusts the charge roller voltage used
when paper with a small width is fed
from the by-pass tray.
Use this SP when an image problem
(such as white spots at the center of
black dots or breaks in thin black
lines) occurs when paper with a small
width is fed from the by-pass feed tray
Adjusts the charge roller voltage used
when paper with a small width is fed
from the by-pass tray.
Use this SP when an image problem
(see 2-13-1) occurs when paper with
a small width is fed from the by-pass
feed tray.
4-10
SERVICE PROGRAM MODE
Function
).
T
for this unit into
TS
Settings
[Default]
1.0 ~ 5.0
0.01V/step
1.00 ~ 5.00
0.01V/step
0 ~ 20
[0]
0 ~ 400
10 V/step
[250 V]
0 ~ 400
10 V/step
[50 V]
SM