Ricoh G035 Service Manual page 521

Rev. 11/2000
⇒
6. Press "Yes" in response to the confirmation message.
7. After successfully downloading the firmware, turn off the machine and
remove the printer controller. Next, remove the ROM DIMM.
8. Reinstall the printer controller and turn on the machine.
4.3.4 FORMATING THE HARD DISK (SP1-4)
This function is used to format the printer hard disk. If the hard disk is formatted,
the stored data (downloaded fonts and macros) will be erased. So, when
performing this function, ask the customer for consent. After this operation, advise
the customer to restore their data, if necessary.
1. Enter the SP mode.
2. Choose "1-4 – Format Disk".
3. Press "Enter #" in reply to the confirmation message. Hard disk formatting will
take several minutes.
4. After confirming that formatting was successful, turn the machine off and back
on again.
G035
DOWNLOADING NEW FIRMWARE
4-24
4-22B
SM