The Customize Menu - Axia element v.2.0 Installation & User Manual

the active software package, click on the radio
button next to the image you wish to activate, and
click this button. A reboot is necessary to load the
new software choice.
»
Delete Current Image:
ton next to software you wish to delete and click
this button. Note that you cannot delete the active
software image.
Good Housekeeping: It's best not to keep too
many old software images around. They clutter
up Element's flash memory, leaving less space
for Show Profiles, syslogs, and other important
data. We recommend that you keep only one
previous software package stored in Element.
»
Upload New Image:
makes new software packages available for down-
load from https://www.telosalliance.com/Axia.
Use the and
Browse
install new software, as described in the Techni-
cal Bulletin that accompanies each software re-
lease.
shuts down Element and restarts it.
»
Reboot
(Remember that mixing takes place in the
StudioEngine, so this can be done even while
you are on the air. Interruptions of your program
stream, if any, will last less than 1 second.) A re-
boot is required after changing active software.

The Customize Menu

This utility allows you to place your sta-
•
User Logo:
tion's logo on the Element operator display. To do so,
create a PNG file in Photoshop or any similar image
editor. This file must measure a maximum of 129 x
97 pixels to fill the allocated display area. Use the
and
Browse Upload User Logo
your logo file. Upon reboot, this logo will appear on
the Operator's display. To delete a displayed logo,
click the
Delete User Logo
You may specify time to be dis-
•
Clock Settings:
played in a 12-hour or 24-hour format. The Element
can optionally display a large digital clock and a
small analog clock as opposed to the default which
is a large analog and small digital. Here is where you
specify your preference. Reboot after changing.
Click the radio but-
From time to time, Axia
buttons to
Upload Image
buttons to install
button and reboot.
©2016 Axia Audio- Rev 1.8.1
Fig. 8-5: Element Customize Screen
Some users may want to change their
•
Fader Offset:
"nominal" fader position. This is a global setting that
permits you to do this. For example, a setting of +6
will increase the "sensitivity" of your faders by 6 dB.
The faders in this example would have to be run 6
dB lower in order for the PGM audio output to be the
same as the -0dB default setting. Your meters will
always represent the actual audio levels.
•
Screenshot Compression:
the Operator's display for documentation, trouble-
shooting or training purposes. You may choose to
save your screenshot in JPEG or PNG format, with
three levels of compression quality using the
and
pression Type Compression Quality
down boxes. Click
Save Settings
done.
•
Element Configuration:
You can save a shot of
Com-
drop-
when you are
This section lets you