Axia element v.2.0 Installation & User Manual page 105

•
CONTROL LOCK MAP:
of these boxes to keep the board op from changing
the selections for this fader's bus assignments, On/
Off state, fader position and several other parameters.
About Channel Lock and Fader Operation:
Say that your station runs syndicated program-
ming overnight, and you want to eliminate the
possibility that the feed could be inadvertently
disrupted. Choose Lock for the channel the feed
is assigned to, and the channel cannot be turned
off, or bus assignment changed, until the channel
is unlocked.
When you load a
which specifies a Locked fader, the
gain value is locked to the posi-
tion of the fader at the moment
the Show Profile is loaded.
When you Unlock the fader using the
Channel Options menu, the fader will
resume working normally from the
current position. You can move it and
lock again in a different position if you
wish.
If the fader has been moved, the first
touch after Unlocking immediately
resets the gain to the fader's current
position.
Specify whether this
•
GROUP START:
fader is a
Master, Slave
This setting is tied to those dis-
dent.
played in the Show Profile Group Start
Screen; a change made here will apply
on the Group Start Screen, and vice-
versa. (For information on the Group Start Function,
please refer to the Group Start Screen description
later in this chapter.
•
MOTOR FADER POSITION:
faders can be set to assume a predefined position
when a Show Profile is loaded. Choose
a setting of -∞, to specify a level to use (from -73
Use
dB to +10 dB), or
Retain Existing Setting
will cause the motor fader to make no changes to the
position the fader was at prior to loading the Show
Profile.
Place a check mark in any
Show Profile
or
Indepen-
Figure 6-2: an
Element accessory
panel with headphone
Motorized Element
to specify
Off
, which
©2016 Axia Audio- Rev 1.8.1
Individual Headphones Section
Note: These controls apply ONLY IF:
• The loaded source is a Mic-type source.
• The loaded source has an individual head-
phone feed associated with it.
• The position at which the mic is installed also
has an Element accessory panel that allows
talent to select their own headphone feeds
(such as the one shown in Figure 6-2).
•
CURRENT SOURCE:
rently specified for monitoring in the Mon-
itors page of the Show Profile.
•
SOURCE FOR PRESET 1:
the source that will load when the acces-
sory panel's
•
SOURCE FOR PRESET 2:
the source that will load when the acces-
sory panel's
•
HEADPHONES
Specify the initial amount of gain that
the Individual Headphone Feed will have
when the Show Profile loads. Turn then
or
Off
•
TALKBACK START VOLUME LOW
selector
LIMIT:
talkback (-72 to +10 dB. This prevents talent from
"turning off" headphones when talkback is present
and this setting is active.
Record Mode
•
PROGRAM 1 / 2 / 3 /4 Record:
BUS settings for the channel -
when Record Mode is active.
No Change
Disables the Channel
•
ON/OFF:
tion or
No Change
Finishing Up...
Finally, there are two more controls at the very bot-
tom of the screen:
The source cur-
key is pressed.
Ext 1
key is pressed.
Ext 2
MASTER
up to 85 dB of cut.
Use
Specify a minimum gain value for
Allows automatic
Assign, Remove
button func-
On/Off
when Record Mode is active
Specify
Specify
GAIN:
or