Axia element v.2.0 Installation & User Manual page 108

•
TALKBACK GAIN: Use
10 dB gain on the contents of the
can also turn gain adjustment
ing Setting.
•
FEED TO SOURCE SUM GAIN:
compensation (-6 to -3 dB) for mono-sum of talkback
audio sources
•
GPIO CHANNEL FOR EXTERNAL PROFANITY
Enter the Channel Number of the GPIO
DELAY:
port connected to your station's Profanity Delay Unit.
This assigns the
Delay
Module to control your external delay unit.
•
GPIO CHANNEL FOR UP TIMER CONTROL:
the Channel Number of the GPIO port you wish to
use for external control of your
•
GPIO CHANNEL FOR DOWN TIMER CONTROL:
Enter the Channel Number of the GPIO port you
wish to use for external control of your
Additional Meters
Figure 6-4: Show Profile - Additional Meters
This section allows to you specify the meter sources
for the six "extra" meters that can optionally be dis-
played in the centre section of the Element display. The
selections for each of the six meters are extensive and
include:
» all Program, Aux, External, Monitor busses,
Phone, Record
» all Fader Channel sources and backfeeds
» all VMIX inputs, direct, sub and main outputs
» all VMODE inputs and outputs
up to -30 dB attenuation or
bus. You
Talkback
or
Off Retain Exist-
Specify a gain
keys on the Element Master
Enter
.
UP timer
DOWN timer
©2016 Axia Audio- Rev 1.8.1
Sources for External 1 & 2 Section
Figure 6-5: Show Profile - External Sources
•
SOURCE ID FOR EXTERNAL INPUT 1:
drop-down box to specify a source for Monitor 1,
External Input 1.
•
SOURCE ID FOR EXTERNAL INPUT 2:
drop-down box to specify a source for Monitor 1,
External Input 2.
Control Room Monitor (Monitor 1) Options
.
Figure 6-6: Show Profile - CR Monitor Options
•
MONITOR ASSIGNMENT:
PGM2, PGM3, PGM4, AUX A, AUX B, AUX C, AUX
D, EXT1, EXT 2
file to be loaded with nothing assigned to Monitor 1.
•
CR MONITOR MASTER GAIN:
as much as -85 dB of gain reduction on the audio
signal sent to the Monitor 1 Speakers. You can also
turn gain control
•
SIGNAL MODE: CR MONITOR
Choose to load
or if you wish the Pro-
No Source
Allows you to
or
Off Retain Existing Setting.
lets you set the au-
Use the
Use the
PGM1,
Use