Axia element v.2.0 Installation & User Manual page 96

* Choose
Auto-Add
when a designated source's fader is turned
and stop counting when that source is turned
In this mode, the timer will not reset to
Off.
zero when it is started.
Pressing the
Timer Options
menu.
Note: Pressing and holding the Timer Options
Key opens the Clock & Timer Options Menu
discussed in Chapter 1.
•
Reset Key:
Pressing this key resets Element's Count Up Timer
to zero.
•
Freeze Key:
Pressing holds the on-screen Timer display
Freeze
so you may take note of it; the timer continues to count
while the display is frozen, and a second press of the
again displays the running elapsed time counter.
Freeze
•
Start/Stop Key:
If the Count Up Timer is not running, pressing this
starts the count. If the timer is running, pressing this key
stops the countdown and retains the last displayed timer
interval.
Record Mode Section
is a special "one-touch" mode which
Record Mode
can be set to automatically start a designated recorder so
talent can record a phone call or remote interview with
a single button-press.
Record Mode
disabled for each
Show Profile
Profiles", for details).
•
Engage Key:
Press this key to put Element into
Pressing this button activates a pre-determined record-
ing device via GPIO assigned to the record device in
the Show Profile. In addition to triggering a recorder,
Record Mode also changes your headphones and moni-
tors to PGM 4 Record which is indicated by flashing the
PGM 4 indicator.
to have the timer count up
On
key again exits this
can be enabled or
(see Chapter 6, "Show
.
Record Mode
©2016 Axia Audio- Rev 1.8.1
Pressing the
Record Mode
tivates and stops the recorder (via GPIO).
Record Mode
Help (?) Key and Magic Key Sequences
The key (Standard Monitor Module) a spe-
Help( ?)
cial key that displays system information about your Ele-
ment hardware, modules and associated software. Press-
ing this key will pop-up this information in the centre
section of the Element display. Pressing it a second time
will return to normal. The Element will continue to op-
erate as usual when this display is active.
"Magic Key" Sequences for Standard Monitor
Module
The list of "Magic Key" sequences for the Standard
Monitor Module are:
Press and hold the
•
IP Address Book:
key for 5 seconds or press and hold the
tions
and keys for 5 seconds. Press the SoftKnobs as
4 7
prompted to edit , save, reboot or Exit. Be sure to
Reboot after making any changes to this page.
•
Clock & Timer Options:
key for 5 seconds.
Options
Press and hold the
•
Capture Mode:
5 seconds.
Press and hold the
•
Test Mode:
for 5 seconds.
•
Module Information:
and keys for 5 seconds.
* #
- Press and hold the ? key for 5
• "Magic Key" Help
seconds or press
"Magic Key" Sequences for Monitor + 2-Fader
Module
The list of "Magic Key" sequences for the Standard
Monitor Module are:
Press and hold the
•
IP Address Book:
keys on the keypad for 5 seconds. (That's
7
Press the SoftKnobs as prompted to edit , save, re-
boot or Exit. Be sure to Save and Reboot after mak-
ing any changes to this page.
•
Clock & Timer Options:
key for 5 seconds.
Options
Press and hold the
•
Capture Mode:
key a second time deac-
Fader Op-
and
*
Press and hold the
Timer
and keys for
* 2
and and keys
* 2 #
Press ? or press and hold the
* (star), 4
*+I+P
Press and hold the
Timer
&
* (star)
&
.)
2