Axia element v.2.0 Installation & User Manual page 86

key displays the Aux Sends screen.
Figure 5-12: Aux Sends menu screen.
(2-Fader Monitor module only)
» Select/Exit:
This control changes which AUX send the other
control is adjusting. Pressing this knob will exit
the Aux Sends Menu screen.
Rotate these knobs to adjust the
»
Send A/B/C/D:
level of the audio you'll be sending to any or all
of the four Aux Send buses.
Pushing any of the four
»
Pre/Post Fader:
SoftKnobs toggles the activity state of that par-
ticular The state is indicated in the display
Send.
above.
sends the source assigned to the fader
*
On Pre
to the selected Aux Send bus prior to having
its gain adjusted by the fader (fixed level).
sends the source assigned to the fad-
*
On Post
er to the selected Aux Send bus after having
its gain adjusted by the fader (variable level).
*
Off
» Pressing
nel Options screen.
•
Feed To Source Key
If the assigned source (i.e., a codec or phone hybrid)
has an associated backfeed or mix-minus, pressing this
key allows the board op to change the audio supplied
through the backfeed. This selection is normally pre-
set when a Source Profile is constructed (see Chapter
3: Working With Sources, for information on Source
Profiles), but can be modified on-the-fly.
Send
Figure 5-13: Feed to Source menu screen.
» The
Select/Take
through the list of available audio sources that
can supply backfeed or mix-minus.
*
Automatic
©2016 Axia Audio- Rev 1.8.1
sends no audio to the Aux Send bus.
again returns to the Chan-
Aux Sends
knob, when rotated, scrolls
backfeeds audio from the Phone