Axia element v.2.0 Installation & User Manual page 107

General Monitor Options
Figure 6-3: Show Profile - Monitor Settings
Lets you decide globally how the
•
TIMER MODE:
onscreen Count Up (event) timer will behave when
this profile is loaded:
» Choose to start, stop and reset the timer
Manual
by hand using the controls displayed when the
key is pressed.
Timer Options
» Choose
Auto-Reset
ically reset to zero and begin counting whenever
a fader is turned
On
» Choose
Auto-Add
when a fader is turned
when that source is turned
timer will not reset to zero when it is restarted.
•
SHOW TENTHS ON:
down and Count Up timers to show or hide tenths of
a second displays. Choices are:
tenths of a second are hidden on
»
No Timers:
both timers.
tenths are shown only on Count-
»
Down Timers:
down timers.
tenths are shown only on Count Up
»
Up Timers:
and the timer will automat-
.
to have the timer count up
and stop counting
On
In this mode, the
Off.
Allows you to set the Count-
©2016 Axia Audio- Rev 1.8.1
timers.
All timers display tenths of a sec-
»
Both Timers:
ond readouts.
•
PREVIEW INTERLOCK MODE:
sen, pressing any fader's
other, previously-lit
Preview
removing that source from
operator can assign multiple faders to
pushing and holding any lit
pushing other
Preview
is chosen, each
Disable
press-on, press-off latching switch. Multiple faders
can be assigned to
Preview
a second push cancels any individual
signment.
•
SWITCHED METER SOURCE SELECT:
whether the far-right on-screen meter bars will dis-
play levels for the
PROGRAM 4
feeding the Control Room Monitors.
•
PROGRAM 3 METER INPUT:
gram 3, Record, Phone, External 1, External 2.
•
PREVIEW SPEAKER MASTER GAIN:
up to -85 dB of attenuation on the Control Room
Use
Preview speakers, turn gain adjustment
tain Existing Setting
•
SOURCE ID FOR EXTERNAL PREVIEW:
ment's External Preview allows other devices to
route audio into the console's Preview system (speak-
ers and operator headphones). Use this drop-down
box to select the External Preview source for this
Show Profile. Note that this must be enabled by a pin
on the CR Monitor GPIO.
What's External Preview for? The word "Ex-
ternal" refers here to any source not gener-
ated by the studio you're working in. Let's say
you have an intercom system that you want to
feed the console's Preview channel. To do this,
you would take the GPO from the intercom and
use it to gate open the external preview input,
which would be fed by the intercom audio. Voila!
If is cho-
Enable
key causes any
Preview
key to be extinguished,
The board
Preview.
Preview
key while
Preview
keys to add or subtract. If
key works like a
Preview
simply by pushing once;
Preview
Choose
bus or the source
Choose from
Pro-
Lets you
, or
Off Re-
.
Ele-
by
as-