Terminal.assignment.for.cable.gland.-.Position.controller.type.8793; Terminal Assignments Of The Process Actual Value Input - Burkert 8792 Operating Instructions Manual

Type 8792, 8793
Installation
17.3. Terminal assignment for cable gland - position
controller Type 8793
→
First connect the process controller as described in chapter
Position Controller Type 8792.
17.3.1. Terminal assignments of the process actual value input
Input.type* Terminal Configuration
4 – 20 mA
- internally
supplied
GND
Frequency
- internally
supplied
GND
4 – 20 mA
Frequency
- externally
supplied
Pt 100
(see information
below)
* Can be adjusted via software (see chapter Specifying the standard settings).
Table 25: Terminal assignments of the process actual value input
Connect the Pt 100 sensor via 3 cables for cable compensation reasons.
It is essential to bridge Pin 3 and Pin 4 on the sensor.
1 +24 V transmitter input
2 Output from transmitter
3 Bridge after GND (GND from 3-con-
ductor transmitter)
4 not used
GND
1 +24 V sensor supply
2 Clock input +
3 not used
4 Clock input –
GND
1 not used
2 Process actual +
3 Process actual –
4 not used
1 not used
2 Clock input +
3 not used
4 Clock input –
1 not used
2 Process actual 1 (Power supply)
3 Process actual 3 (GND)
4 Process actual 2 (Compensation)
17.2.Terminal Assignment for Cable Gland -
External.circuit
I
1
2
3
GND
1
2
4
GND
2
3
2
4
2
3
4
english
Transmitter
GND
+24 V
Clock +
Clock – (GND)
+ (4 – 20 mA)
GND
Clock +
Clock –
Pt 100
69