Burkert 8792 Operating Instructions Manual page 161

Type 8792, 8793
Start-up, operation
process controller Type 8793
OUT Safepos. Output.of.message:.Actuator.in.safety.position:.
→ .
Press the arrow keys to mark the
(SELEC).
→ .
In the OUT BIN1/2 type menu option input the required switching status (normally open / normally closed)
(see Table 42:).
OUT ERR SP/CMD*.. Output.broken.sensor,.process.set-point.value:
→
.
Press the arrow keys to mark the
right (SELEC).
→ .
In the OUT BIN type menu option input the required switching status (normally open / normally closed)
(see Table 42:).
OUT ERR PV*.. Output.broken.sensor,.process.actual.value:
→
.
Press the arrow keys to mark the
(SELEC).
→
.
In the OUT BIN1/2 type menu option input the required switching status (normally open / normally closed)
(see Table 42:).
OUT remote.. Output.operating.state.AuTOMATIC./.MAnuAl:
→
.
Press the arrow keys to mark the
(SELEC).
→ .
In the OUT BIN type menu option input the required switching status (normally open / normally closed)
(see Table 42:).
OUT BIN1/2
AUTOMATIC operating state
MANUAL operating state
* Normally open- output, in switched state high (≅ 24 V)
** Normally closed- output, in switched state low (≅ 0 V)
Table 42: witching status OUT BIN - MANUAL / AUTOMATIC; process controller Type 8793
* only possible if signal level fault detection activated (see chapter 24.4.SIG-ERROR Configuration of signal level fault
detection).
OUT Safepos menu option and confirm with the selection key on the right
OUT ERR SP/CMD menu option and confirm with the selection key on the
OUT ERR PV menu option and confirm with the selection key on the right
OUT remote menu option and confirm with the selection key on the right
normally open
0 V
24 V
normally closed
24 V
0 V
english english
161