Switching.between.the.operating.levels; Automatic.operating.state; Meaning Of The Keys - Burkert 8792 Operating Instructions Manual

23.2. switching between the operating levels
Process.operating.level.->.Configuration.level
To switch to the configuration level in the MANUAL or AUTOMATIC operating state
→
.
hold down the left selection key (MENU) for approx. 3 seconds (countdown: two bars converge on the
display).
At the Configuration level the operating parameters can be input or changed, auxiliary functions supplemented or
the automatic adjustment (X.TUNE) of the controller started.
A precise description of the individual functions can be found in chapter Configuring the auxiliary
functions.
Configuration.level.->.Process.operating.level
Press the left selection key (EXIT) to switch from the Configuration level to the Process operating level. In doing so,
the operating state which was selected before the switchover (AUTOMATIC or MANUAL) is set.
23.3. auTOMaTic operating state
Bar running from left to right along the upper edge of the display.
Normal control mode is implemented and monitored in AUTOMATIC operating state.
23.3.1. Meaning of the keys
key
Left selection key
Right selection key
Up arrow key
Down arrow key
* Displayed only when P.CONTROL auxiliary function activated
Table 38: AUTOMATIC operating state; Meaning of the keys; Process controller Type 8793
146
Configuration*
MENU
MANU
SP
SP/PV graphic
POS
CMD
TEMP
PV
CMD
TEMP
PV
SP
SP/PV graphic
POS
english english
Description
Switch to the Configuration level (press for approx. 3 s)
Switch between the AUTOMATIC (AUTO) or MANUAL (MANU)
operating modes
Switch between the individual displays
Type 8792, 8793
Start-up, operation
process controller Type 8793