Starting.up.and.adjusting.the.process.controller; Starting.up.and.adjusting.the.process.controller; Safety.instructions; Installation - Burkert 8792 Operating Instructions Manual

Type 8792, 8793
Start-up, operation
process controller Type 8793
22. sTarTing up and adjusTing The
prOcess cOnTrOller
22.1. safety instructions
danGer!
risk.of.injury.from.high.pressure.in.the.equipment!
• Before loosening the lines and valves, turn off the pressure and vent the lines.
WarnInG!
risk.of.injury.from.improper.start-up!
• Start-up may be carried out by authorised technicians only and with the appropriate tools!
risk.of.injury.from.unintentional.activation.of.the.system.and.an.uncontrolled.restart!
• Secure system from unintentional activation.
• Following start-up, ensure a controlled restart.
22.2.

installation

→
.
Before start-up, carry out fluid and electrical installation of the positioner and valve.
To set up the positioner as a process controller, it is first necessary to specify the basic functions of the
position controller and then supplement the auxiliary functions for the process control.
22.3. procedure for specifying the settings
When the operating voltage has been switched on, the positioner is at the process operating level in the AUTOMATIC
operating state.
To specify the standard settings, switch to the configuration level.
→
.
Hold down the left selection key (MENU) for approx. 3 seconds (wait for countdown on display).
Then the main menu is indicated on the display (MAIN).
→ .
Use the arrow keys to switch between the main menu options and select a menu.
→
.
Press the right selection key (ENTER/RUN) to confirm the selection.
Depending on the function, a menu sub-option or a selection screen is indicated on the display.
Use the arrow keys to switch between the submenu options and select the required settings.
→
.
Press the right selection key (SELEC/ENTER) to confirm the selection (the dot after the selected parameter is
now marked).
english english
123