Burkert 8792 Operating Instructions Manual page 132

Procedure.for.setting.the.scaling.values:
Inputting.the.unit.and.the.position.of.the.decimal.point.for.the.scaling.values.(possible.in.PVmin.only):
→
.
Using the arrow keys, select the
(ENTER).
→
.
Press the right selection key (INPUT) to switch to the input screen for
On the display the field for the unit has a dark background and is therefore marked.
→
.
Press the up arrow key (+) to select the unit (bar, mbar, .... °F) for the scaling values. The units indicated here
depend on the signal type (PV INPUT).
→
.
Press the down arrow key (
→
.
Press the up arrow key (+) to specify the position of the decimal point.
Inputting.the.scaling.value:
→
.
Press the down arrow key (
→
.
Press the up arrow key (+) to specify the value of the individual digit.
→
.
Press the down arrow key (
→ .
When all input values have been specified, confirm the values by pressing the right selection key (OK).
The menu then jumps back to the selection screen.
⑧
a . . P V-SCALE.-.Scaling.the.process.actual.value.for.signal.type.4.–.20.mA (PV-INPUT 4 – 20 mA)
With the PV-SCALE function for signal type 4 – 20 mA the following settings are specified:
• The unit of the process actual value.
• The position of the decimal point.
• The values for the lower and upper process actual value are assigned to the respective current value of the unit
signal.
If the settings for the unit of the process actual value or the position of the decimal point are input or
changed, this setting applies to all scaling values (PVmin, PVmax, SPmin, SPmax).
132
PV SCALE menu option and confirm by pressing the right selection key
←) to change the dark highlighted background to the decimal point of the value.
←) to change the dark highlighted background to the last digit of the value.
←) to switch to the next digit.
english english
Type 8792, 8793
Start-up, operation
process controller Type 8793
PVmin.