Operating Voltage; Connecting The External Position Measuring System (For Remote Model Only) - Burkert 8792 Operating Instructions Manual

17.2.3. Operating voltage
Terminal Configuration
+24 V

Operating voltage +

GND Operating voltage GND
Table 23: Pin assignment; operating voltage - M12, 8-pole circular connector
17.2.4. connecting the external position measuring system
(for remote model only)
Terminal Configuration
S + Supply sensor +
S - Supply sensor –
A Serial interface, A cable
B Serial interface, B-cable
Table 24: Terminal assignment; external position measuring system
When the power supply voltage is applied, the positioner is operating.
→
Now make the required basic settings and actuate the automatic adjustment of the positioner. The procedure is
described in chapter Initial start-up and chapter Starting up and adjusting the position controller.
68
english
External.circuit./.Signal.level
+24 V
GND
External.circuit./.Signal.level
S + +
S – –
A A line
B B line
Type 8792, 8793
Installation
24 V DC ± 10%
max. residual ripple 10%
Remote
Sensor
Typ 8798