Switching.between.the.operating.levels; Automatic.operating.state; Meaning Of The Keys - Burkert 8792 Operating Instructions Manual

20.2. switching between the operating levels
Process.operating.level.->.Configuration.level
To switch to the configuration level in the MANUAL or AUTOMATIC operating state
→
hold down the left selection key (MENU) for approx. 3 seconds (Countdown: two bars converge on the
display).
At the Configuration level the operating parameters can be input or changed, auxiliary functions supplemented or
the automatic adjustment (X.TUNE) of the controller started.
A precise description of the individual functions can be found in chapter 21.Configuring the auxiliary
functions.
Configuration.level.->.Process.operating.level
Press the left selection key (EXIT) to switch from the Configuration level to the Process operating level. In doing so,
the operating state which was selected before the switchover (AUTOMATIC or MANUAL) is set.
20.3. auTOMaTic operating state
Bar running from left to right along the upper edge of the display.
Normal control mode is implemented and monitored in AUTOMATIC operating state.
20.3.1. Meaning of the keys
key
Left selection key
Right selection key
Up arrow key
Down arrow key
Table 28: AUTOMATIC operating state; Meaning of the keys; Position controller type Type 8792
86
Configu-
ration
MENU
MANU
INPUT
POS
CMD
TEMP
CMD
TEMP
INPUT
POS
english
Description
Switch to the Configuration level (press for approx. 3 s)
Switch between the AUTOMATIC (AUTO) or MANUAL (MANU)
operating modes
Switch between the individual displays
Type 8792, 8793 Type 8792, 8793
Start-up, operation
position controller Type 8792