Attaching Mounting Bracket - Burkert 8792 Operating Instructions Manual

Type 8792, 8793
Installation
14.2.3. attaching mounting bracket
→
Attach mounting bracket
(see Fig. 16:).
The selection of the M8 thread used on the positioner depends on the size of the actuator.
→
To determine the correct position, hold the positioner with mounting bracket on the actuator.
The conical roller on the lever of the position measuring system in the hoop must be able to run freely on the
drive over the entire stroke range.
At 50% stroke the lever position should be approximately horizontal (see chapter 14.2.4.Aligning lever
mechanism).
①
Fig. 16:

Attaching mounting bracket

Attaching.the.positioner.with.mounting.bracket.for.actuators.with.cast.frame:
→
Attach mounting bracket to the cast frame with one or more hexagon bolts
(see Fig. 17:).
Fig. 17: Attach positioner with mounting bracket; for actuators with cast frame
①
to the back of the positioner with hexagon bolts
⑨
⑩ ⑪
⑨ ⑩
, circlip
⑧ ⑪
, washers
8
10
11
english
⑪
and washers
⑩
and circlips
51