Protection Elements - GE Multilin G650 Manual

5.8 RELAY CONFIGURATION
This tab allows assigning operands (logic signals) as inputs to different protection elements. This way, the user assigns
etc. In this screen we can also configure a logic signal to perform the LED reset by communications.
The settings are as follows:
• Select checkbox enables/disables the selection.
• Source setting defines the operand that performs the function indicated in the SELECT column. NOT setting inverts
the block signal.
• NOT setting for inverting the logic signal.
• OR checkbox to select a group of operands instead of a single one. The relay performs an OR of the signals, and its
output produces the operation.
The following figure shows this screen:
5
5-130 G650 Generator Protection & Control System
5 SETTINGS

5.8.4 PROTECTION ELEMENTS

GEK-113285A