GE Multilin G650 Manual page 116

4 HUMAN INTERFACES. SETTINGS & ACTUAL VALUES
4.2.5.6 VIEW SETTINGS
To enter this menu press the shuttle key when the option "View Settings" is selected in main menu ( ). A secondary level
will be displayed with different sublevels as shown on Table 4–30:. Rotating the shuttle key, (left for moving up and right for
moving down) select the next level to be displayed ( ), press the shuttle key again to enter in next level and press esc key
to return to previous level if desired. This navigation will be performed the same for all the menus in "View Settings". Once
the last sublevel is reached, move up and down to visualize the settings selected.
Table 4–30: GENERAL OVERVIEW OF "VIEW/CHANGE SETTINGS" MAIN MENU
MAIN SETTINGS MENU
Product Setup >
System Setup >
Protection Element >
GEK-113285A
FIRST LEVEL
Communication >
Fault Report
Oscillography
Demand
General Settings
Breaker >
Phase Current >
Neutral Current >
G650 Generator Protection & Control System
4.2 HUMAN MACHINE INTERFACE (HMI)
SECOND LEVEL
Serial Ports
Ethernet >
ModBus Protocol
DNP3 Slave >
IEC 870-5-104>
SNTP
Breaker Settings
Breaker Maintenance
Phase TOC High >
Phase TOC Low >
Phase IOC High >
Gen. Thermal Model >
Neutral TOC >
Neutral IOC >
THIRD LEVEL
Ethernet 1
Ethernet 2
DNP3 Slave 1
DNP3 Slave 2
DNP3 Slave 3
Phase TOC High 1
Phase TOC High 2
Phase TOC High 3
Phase TOC Low 1
Phase TOC Low 2
Phase TOC Low 3
Phase IOC High 1
Phase IOC High 2
Phase IOC High 3
Gen Thermal Model 1
Gen Thermal Model 2
Gen Thermal Model 3
Neutral TOC 1
Neutral TOC 2
Neutral TOC 3
4-41
4