Creating A Step 7 Project - Siemens SINAMICS G120 Operating Instructions Manual

Appendix
A.1 Application examples
In order to configure communication you also require the following software packages:
Table A- 2
Component
SIMATIC STEP 7
STARTER
Drive ES Basic is the basic software of the engineering system, which combines the drive
technology and Siemens controllers. The STEP 7 Manager user interface acts as a basis
with which Drive ES Basic is used to integrate drives in the automation environment with
respect to communication, configuration, and data storage.
A.1.1.3

Creating a STEP 7 project

PROFIBUS communication between the inverter and a SIMATIC control is configured using
the SIMATIC STEP 7 and HW Config software tools.
Procedure
● Create a new STEP 7 project and assign a project name, e.g. "G120_in_S7". Add an S7
● Select the SIMATIC 300 station in your project and open the hardware configuration (HW
● Add an S7 300 mounting rail to your project by dragging and dropping it from the
292
Software components
300 CPU.
Figure A-1 Inserting a SIMATIC 300 station into a STEP 7 project
Config) by double clicking on "Hardware".
"SIMATIC 300" hardware catalog. Locate a power supply at slot 1 of the mounting rail
and a CPU 315-2 DP at slot 2.
Type (or higher)
V5.3 + SP3
V4.2
Operating Instructions, 01/2011, FW 4.4, A5E02999804A AB
Order no.
6ES7810-4CC07-0YA5
6SL3072-0AA00-0AG0
SINAMICS G120C Inverter
Qty
1
1