Siemens SINAMICS G120 Operating Instructions Manual page 57

Factory pre-assignment of the terminal block at the inverter with PROFIBUS interface
Figure 5-3
Note
Assignment of terminals following basic commissioning
The inverter is assigned in the same way as the inverter without PROFIBUS interface when
you deselect bus communication for both the command sources and the setpoint value
specification during basic commissioning of the inverter.
SINAMICS G120C Inverter
Operating Instructions, 01/2011, FW 4.4, A5E02999804A AB
Default wiring using PROFIBUS communications
5.3 Commissioning with factory settings
Commissioning
55