Freely Selecting And Changing Parameters - Siemens SINAMICS G120 Operating Instructions Manual

Commissioning
5.4 Commissioning with Operator Panel BOP-2
5.4.3

Freely selecting and changing parameters

Use BOP-2 to change your inverter settings, by selecting the appropriate parameter number
and changing the parameter value. Parameter values can be changed in the "PARAMS"
menu and the "SETUP" menu.
Select the parameter number
If the parameter number flashes in the display,
you have two options for changing the number:
1. option:
Increase or decrease
the parameter number
using the arrow keys
until the number you
want is displayed.
Confirm the parameter number using the OK key. Confirm the parameter value using the OK key.
The inverter immediately saves all changes which you made using the BOP-2 so that they
are protected against power failure.
58
OK
>2 sec
ESC OK
OK OK
ESC ESC ESC
2. option:
Press and hold the OK
key for more than two
seconds and change
the required parameter
number digit by digit.
OK OK OK
ESC
Changing a parameter value
If the parameter value flashes in the display, you
have two options of changing the value:
1. option:
Increase or decrease
the parameter value
using the arrow keys
until the value you want
is displayed.
Operating Instructions, 01/2011, FW 4.4, A5E02999804A AB
OK
>2 sec
ESC OK
OK OK
ESC ESC ESC
2. option:
Press and hold the OK
key for more than two
seconds and enter the
required value digit by
digit.
SINAMICS G120C Inverter
OK OK