Selecting The Interface Assignments - Siemens SINAMICS G120 Operating Instructions Manual

4.4.6

Selecting the interface assignments

The inverter offers multiple predefined settings for its interfaces.
One of these predefined settings matches your particular application
Proceed as follows:
1. Wire the inverter corresponding to your application.
2. Carry-out the basic commissioning, see Section Commissioning (Page 47).
3. When required, configure communication via fieldbus, see Configuring the fieldbus
What do you do if none of the predefined settings matches your particular application 100%?
If none of the predefined settings matches your particular application, then proceed as
follows:
1. Wire the inverter corresponding to your application.
2. Carry-out the basic commissioning, see Section Commissioning (Page 47).
3. Adapt the inputs and outputs to your application, see Section Adapting the terminal strip
4. When required, configure communication via fieldbus, see Configuring the fieldbus
SINAMICS G120C Inverter
Operating Instructions, 01/2011, FW 4.4, A5E02999804A AB
In the basic commissioning, select the macro (the predefined settings of the interfaces)
that matches your particular wiring.
(Page 91).
In the basic commissioning, select the macro (the predefined settings of the interfaces)
that comes the closest to matching your particular application.
(Page 79).
(Page 91).
Installing
4.4 Connecting the inverter
41