5
6
7
Remove the seal holding the
staples together, by pulling it
straight out, and then down.
IMPORTANT
Make sure that you pull the seal straight
out, and then down. If you pull it out at an
angle, it may tear.
Gently push the staple case into
the finisher, until it is securely in
place.
Close the front cover of the
finisher.
CAUTION
When closing the front cover of the
finisher, be careful not to get your
fingers caught, as this may result in
personal injury.
NOTE
If there are no staples ready for stapling
after the cover is closed, the stapler unit
automatically performs a "dry" stapling
operation to reposition the staples.
Replacing the Staple Cartridge
6
6-23