Standard Paper For The Stack Bypass - Canon imageRUNNER 2320 Reference Manual

Standard Paper for the Stack Bypass

You can set the paper size and type that the stack bypass uses beforehand. This
setting is useful if you always load the same paper size and type into the stack
bypass.
IMPORTANT
When printing on special types of paper, such as heavyweight paper or transparencies,
make sure to correctly set the paper type, especially if you are using heavyweight paper.
If the type of paper is not set correctly, it could adversely affect the quality of the image.
Moreover, the fixing unit may become dirty and require a service repair to avoid a paper
jam.
NOTE
•
If you are going to use the stack bypass as a paper source for the Copy function, you
must set the stack bypass to 'On' when specifying the Auto Drawer Selection setting.
(See "Auto Paper Selection/Auto Drawer Switching," on p. 3-11.)
•
The default setting is 'Off'.
1
Press
<Common Settings> ➞ press [OK].
For help, see the screen shots in step 2 of "Initial Function at Power ON," on p. 3-5.
The Common Settings menu appears.
2
Common Settings
Auto Drawer Select
Register Paper Type
Tray Designation
Stand. Stack Bypass
3
Stand. Stack Bypass
Off
On
(Additional Functions) ➞ use [
] or [ ] to select
Use [ ] or [ ] to select <Stand.
Stack Bypass> ➞ press [OK].
The Stand. Stack Bypass menu appears.
] to select <On> ➞
Use [ ] or [
press [OK].
If you select <Off>, proceed to step 8.
NOTE
Select <Off> if you want to specify the
paper size/type every time paper is fed
from the stack bypass. (See "Feeding
Paper Using the Stack Bypass," on
p. 2-25.)
Specifying Common Settings
3
3-17