Feeding Paper Using The Stack Bypass - Canon imageRUNNER 2320 Reference Manual

Feeding Paper Using the Stack Bypass

If you are making prints on transparencies, labels, nonstandard paper size stock, or
envelopes, load the paper stock into the stack bypass.
IMPORTANT
•
If you are using the stack bypass as a paper source for the Copy function, you must
select the stack bypass when specifying the Auto Drawer Selection setting. (See "Auto
Paper Selection/Auto Drawer Switching," on p. 3-11.)
•
Paper loaded on the stack bypass must meet the following requirements:
- Paper Quantity: one to approximately 80 sheets (80 g/m
high)
- Paper Size: 95 mm × 148 mm to 297 mm × 432 mm
- Paper Weight: 64 g/m
•
Rolled or curled paper must be straightened out prior to use, to allow the paper to feed
smoothly through the stack bypass (allowable curl amount: less than 10 mm for normal
paper, less than 5 mm for heavyweight paper).
•
If the paper has absorbed moisture while in storage in a humid environment, it may not
be possible to feed the paper into the stack bypass. In this case, set the amount of paper
to fewer than 40 sheets (80 g/m
•
Do not load different size/type paper at the same time.
•
Feed label sheets one sheet at a time, and remove each sheet as it is delivered to the
output tray. Loading several label sheets together may cause paper jams.
•
Loading multiple sheets of heavyweight paper into the stack bypass may cause a paper
jam, depending on the type of heavyweight paper you want to use. Load only one sheet
at a time.
•
When printing on special types of paper, such as heavyweight paper or transparencies,
be sure to set the correct paper type, especially if you are using heavyweight paper. If the
type of paper is not set correctly, it could adversely affect the quality of the image.
Moreover, the fixing unit may become dirty and require a service repair, or the paper
could jam.
•
If you are printing on envelopes, do not allow more than 10 envelopes to accumulate in
the output tray. Always empty the output tray once 10 envelopes have accumulated.
NOTE
•
Envelopes may become creased in the printing process.
•
For high-quality printouts, use paper recommended by Canon.
•
For more information on paper types that can be used with this machine, see "Available
Paper Stock," on p. 8-17.
2 2
to 128 g/m
2
).
2
, stacked approximately 5 mm
Basic Copying
2
2-25