Table of Contents
Advertisement
Section 3
TYPICAL TECHNICAL DATA
Enclosure:
Dimensions (HxWxD):
Weight:
Power Consumption:
Mains Connection:
Mains Wire Specification:
Signal Wire Specification:
FEATURES IN DETAIL
Display:
Data Storage:
SD/MMC Card:
Operation:
Language Options:
INPUT & OUTPUT SIGNALS
Standard Output:
Digital Output:
Data Transfer Port:
OPTIONAL FEATURES
Result Output:
Remote Control:
Industrial Interface:
Calibration & Cleaning:
Multi-stream:
Manual stream:
Technical Specifications
Fiberglass Reinforced Polyester
1250mm x 750mm x 320mm
Enclosure height may increase to 1750mm, depending on system optional
features.
90 kg – 120 kg
Enclosure weight may change depending on system optional features.
300 W (VA)
115V AC, 60Hz or 230V AC, 50Hz (10%)
Other power options are available on request.
Number of Cores = 3, Current Rating minimum = 10 Amps, CSA (Cross
Sectional Area minimum) = 1.50mm
Number of Cores = 8 (+2 cores per additional signal), Current Rating
minimum = 1 Amp, CSA (Cross Sectional Area minimum) = 0.22mm
High Contrast 40 Character x 16 Line Backlit LCD with CFL Backlight
Previous 9999 analysis data on screen in the microcontroller memory and
storage of data archive for the lifetime of the analyzer in the SD/MMC card
Previous 99 fault data on screen in the microcontroller memory and storage
of fault data archive for the lifetime of the analyzer in the SD/MMC card
Flash memory card for data transfer and for software & configuration updates
Microcontroller with BioTector OS3 Software and Membrane Keyboard
English, French, German
Other language options are available on request.
One programmable 4-20mA output signal (typically for TOC)
For systems requiring more than six 4-20mA standard outputs, 4-20mA
Output Multiplex option is implemented to provide 4-20mA data for up to 35
output signals.
Three freely programmable system relays (volt free changeover contact with
a current rating of 1Amp at 30V DC)
One of the system relay is factory set to Fault.
SD/MMC Card and serial RS232 Output for Printer, PC or Data Logger
TIC, TC, VOC, after correlation COD, BOD
Input for remote start / standby
Input for remote stream and range selection
Input for remote manual grab sample analysis
Network Control Unit for remote access over Internet or Intranet connection
using HTTP over TCP/IP protocol
Modbus, Profibus, Ethernet
(when any of the Modbus, Profibus or Ethernet option is selected, the digital
output signals are sent through the relevant device with its specific
communication protocol)
Valves for Automatic Calibration and Sample Line Cleaning
Valves for up to 6 streams with up to six 4-20mA signals (TIC & TOC, TC,
VOC systems). The number of available outputs depends on the manual
stream configuration.
Valves for up to 6 manual streams with up to six 4-20mA signals (TIC & TOC,
TC, VOC systems). The number of available outputs depends on the multi-
stream configuration.
2
2
.
Page 35
Advertisement
Table of Contents
