Setting The 10Baset Port Ip Address - Paradyne 3160-A4 Operator's Manual

4. Configuration

Setting the 10BaseT Port IP Address

The 10BaseT port IP address (ENET IP Adr on the front panel) is the address
used by the SNMP or Telnet system to access the DSU/CSU through the 10BaseT
port (see
The example below shows an IP address of 010.155.111.222 being set for the
10BaseT port. You can use the same principles to assign any valid value to each
of the four bytes of the IP address. Valid values are 000–126 and 128–223 for the
first byte, and 000–255 for the remaining bytes.
Procedure
To assign an IP address to the 10BaseT port:
4-10
Appendix G, IP Network Addressing Scenarios
1. From the top-level menu screen, select Cnfig.
2. Select the configuration option set to be copied into the Edit area by using the
appropriate Function key. Use the scroll keys, if necessary.
3. Select Edit.
4. From the Edit screen, press the
screen.
5. Select User.
Edit:
User Alarm
F1 F2
6. Press F1 (Next) until the ENET IP Adr configuration option appears.
7. Press F2 (Edit) to edit the IP address. You have the option of using F3 (Clear)
to reset the IP address to the factory default 000.000.000.000 .
ENET IP Adr:
Next Edit
F2
F1
8. Use the and keys to position the cursor under the digit you want to
change. Press F1 (Up) to increment the digit or F2 (Down) to decrement the
digit. For example, press
the first byte field, then press F1 (Up) once to change the 0 to a 1. Continue in
this manner to change the other digits.
010.000.000.000
Up Down
F2
F1
March 2001
).
key until the User selection appears on the
Mgmt
F3
Clear
F3
once to place the cursor under the middle digit in
Save
F3
3160-A2-GB24-10