Paradyne 3160-A4 Operator's Manual page 99

The carrier COM port provides the following functionality:
T
T
T
The set of valid characters for control of the carrier external COM port device is as
follows:
T
T
T
T
T
T
T
3160-A2-GB24-10
If configured for ASCII, only one ASCII device may be used for the carrier. (If
two COM ports are configured for ASCII, neither will work.)
If configured for Mgmt, each device in the carrier can support an Mgmt COM
port; however, each Mgmt COM port must be connected to a different subnet.
To facilitate IP data routing, the device with the closest link to the SNMP
manager or Telnet client should be configured as the IP Bus Master.
If configured for either ASCII or Mgmt, the carrier COM port may be configured
to control an external device (e.g., modem, x.25 PAD) through the use of AT or
user-specified commands.
The numbers: 0–9
The lowercase letters: a–z
The uppercase letters: A–Z
The space (" ") character
The ASCII symbols (in ascending order, based on the ASCII code)
The End Of Line (EOL) symbol:
The caret ("^") control character is used to select non-printable ASCII
characters. The caret "^" must be followed by one character which together
form the control sequence.
available control sequences.
March 2001
Table 4-2, Control Sequence, defines all of the
4. Configuration
4-45