Displaying Dsu/Csu Test Status - Paradyne 3160-A4 Operator's Manual

Displaying DSU/CSU Test Status

Use the Test Status command to display the active tests for the DSU/CSU. Status
messages that can display on the front panel LCD are listed in
Status
Procedure
To display test status:
Table 8-4.
3160-A2-GB24-10
Message.
1. From the top-level menu screen, select Stat.
2. From the Status screen, press the
the screen.
3. Select TStat.
Status:
STest Perf
F1
The Test Status screen appears showing you what tests are active for the
DSU/CSU.
Test Status Message
Message Description
1–8 Test Active A 1-in-8 test pattern is being sent on the network interface.
511 on Port n A 511 test pattern is being sent to the network on the channels
allocated to port n .
DCLB on Port n Port n is in a Data Channel loopback.
DLB Test Active The DTE Drop/Insert (DSX-1) port is in DTE loopback.
DLB Test, Extrn The DTE Drop/Insert (DSX-1) port is being held in DTE loopback by
the external contact.
DTLB on Port n Port n is in a Data Terminal loopback.
Lamp Test Active The Lamp test is currently active.
LLB Test Active The network interface is in Line loopback.
Mon 511, Port n A 511 test pattern is being monitored on the channels allocated to
port n .
Mon QRSS, Net A QRSS test pattern is being monitored on the network interface.
Mon QRSS, Port n A QRSS test pattern is being monitored on the channels allocated to
port n .
No Test Active No tests are currently active.
PLB Test Active The network interface is in Payload loopback.
RLB Test Active The DTE Drop/Insert (DSX-1) port is in Repeater loopback.
QRSS on Net A QRSS test pattern is being sent on the network interface.
QRSS on Port n A QRSS test pattern is being sent to the network on the channels
allocated to port n .
March 2001
key until the TStat selection appears on
TStat
F2 F3
8. Testing
Table 8-4, Test
8-23