Initiating A Call For Front Panel Pass-Through Operation - Paradyne 3160-A3 Operator's Manual

Table 3-6.

Initiating a Call for Front Panel Pass-Through Operation

Front panel pass-through initiates a call through the integral modem to access a
far-end DSU/CSU's front panel from your DSU/CSU's front panel (or PC attached
to the COM port).
3160-A2-GB21-90
Valid Phone Number Characters
Valid
Characters Meaning
0 to 9 DTMF or pulse digits
* # DTMF digits
P Selects Pulse dialing
T Selects Tone (DTMF) dialing
W Wait for dial tone
B Blind dialing (you need not wait
for a dial tone before entering
the dialing sequence)
, Creates a 2-second pause in
the dialing sequence
<space> ( ) - Extra characters for readability.
The space is the default
character.
<- End Of Number (EON)
character, terminates the dial
string and erases all characters
to the right after F3 (Save) is
pressed
NOTE:
Pass is only available when the FP Pass configuration option has been
enabled (see Appendix C, Configuration Options
is either the front panel or the PC, and the integral modem is not already in
use.
February 2001
Restrictions
—
—
Pulse or Tone must be specified,
otherwise Tone is the default. This must
be the first character in the string,
unless the first character is B. Then, it
must immediately follow the B.
Tone or Pulse must be specified,
otherwise Tone is the default. This must
be the first character in the string,
unless the first character is B. Then, it
must immediately follow the B.
—
To be valid, this must be the first
character in the string.
—
—
—
), the active physical interface
3. Operation
3-57