Paradyne 3160-A3 Operator's Manual page 182

C. Configuration Options
Table C-9. General Management Configuration Options (7 of 7)
C-38
Def Netwk: None
Next None IPBus Com
EDL4 Prev
Default Network Destination. Specifies the default network destination. This configuration
option specifies where the default network is connected. For example, if the default
network is connected to the communication port, you select Com. If the default network is
connected to the far-end 31xx Series device over the FDL, you select FDL. The routing
protocol uses the default network destination to route data that does not have a specific
route.
None – No default network destination. Data that cannot be routed is discarded.
IPBus – The default network destination is the IP Bus on the carrier backplane. This
selection only appears for carrier-mounted DSU/CSUs which are not configured as the IP
Bus Master.
Com – The default network destination is the communication port. This selection only
appears if the Com Use configuration option is set to Mgmt.
Modem – The default network destination is the modem port. This selection only appears
if the Modem Use configuration option is set to Mgmt. This selection does not appear on
carrier-mounted DSU/CSUs.
Aux – The default network destination is the auxiliary port. This selection only appears if
the Aux Use configuration option is set to Mgmt.
FDL – The default network destination is FDL. This selection only appears if the FDL
management link is enabled.
EDL n – For 2-port and 4-port DSU/CSUs, the default network destination is the EDL n port
(where n is 1–4). This selection only appears in 2-port and 4-port DSU/CSUs if the
synchronous data port's EDL management link is enabled.
NOTE: If the chosen default network link is disabled or down, data is discarded. Return
to this menu and choose another default network.
February 2001
Modem Aux FDL EDL1 EDL2 EDL3
3160-A2-GB21-90