Allocating Ds0 Channels From The Dte Drop/Insert Interface - Paradyne 3160-A3 Operator's Manual

3. Operation
Allocating DS0 Channels from the DTE Drop/Insert Interface to the Network Interface
By using the configuration options, you can allocate DS0 channels from the DTE
Drop/Insert (DSX-1) interface to the network interface and specify which DS0
channels carry Robbed Bit Signaling (RBS) information for voice channels.
Procedure
To allocate DS0 channels from the DTE Drop/Insert (DSX-1) interface to the
network interface:
3-42
4. Line 1 displays the 24 channels for the network interface or the DTE
Drop/Insert (DSX-1) interface, depending on which destination was chosen.
This example assumes that the network is the destination. Line 2 displays
what is allocated to the DS0 channel shown in Line 1. Pressing the
key scrolls the channels onto the screen in groups of three. Select the channel
by pressing the Function key under the desired number. Port n appears. The
port is assigned to that channel. To deallocate a port, press the Function key
under that port number. Pressing the Function key under channels assigned to
other ports has no effect.
N1
Next Prt1
F1 F2
1. From the top-level menu screen, select Cnfig.
2. Select the configuration option set to be copied into the Edit area by using the
appropriate Function key. Use the scroll keys, if necessary.
3. Select Edit.
4. From the Edit screen, press the
the screen.
5. Select Chan.
Edit:
Port NET
F2
F1
6. From the Channel Config screen, select DTE.
Channel Config:
Dsply Clear
F2
F1
February 2001
N2
Prt2
F3
key until the Chan selection appears on
Chan
F3
DTE
F3
or
3160-A2-GB21-90