Initiating A Call For Front Panel Pass-Through Operation; Initiating A Call For Pc Or Ascii Terminal/Printer Operation - Paradyne 3163 User Manual

ACCULINK 3163 DSU/CSU
Initiating a Call for Front Panel
Pass-Through Operation
Front panel pass-through initiates a call through the
integral modem to access a far-end DSU/CSU's front
panel from your DSU/CSU's front panel (or PC attached
to the COM port).
NOTE
Pass is only available when the
FP Pass configuration option has
been enabled (see Appendix C,
Configuration Options), the active
physical interface is either the
front panel or the PC, and the
integral modem is not already in
use.
"
Procedure
To initiate front panel pass-through at the near-end
DSU/CSU:
1. From the top-level menu screen, press the
until the Ctrl selection appears on the screen.
2. Select Ctrl.
3. From the Control screen, select Call.
Control:
Call
F1
4. From the Call Setup screen, select Pass.
Call Setup:
Pass
F1
3-26
key
Rel LED
F3
F2
Dial ChDir
F3
F2
5. From the Pass Directory screen, press F1 (Up) to
display the next higher numbered directory or
press F2 (Down) to select the next lower
numbered directory.
6. When the number of the desired directory appears
on the screen, press F3 (Dial) to place the call.
Initiating a Call for PC or ASCII
Terminal/Printer Operation
Use the Dial command to set up a semipermanent
connection to route alarm messages to the specified
destination. The Dial command initiates a call through the
integral modem to a printer, ASCII terminal, or PC.
"
Procedure
To initiate a call at the local DSU/CSU:
1. From the top-level menu screen, press the
until the Ctrl selection appears on the screen.
2. Select Ctrl.
3. From the Control screen, select Call.
March 1999
Pass n : xxxxxxxxx
Up Down Dial
F1 F2 F3
Pass n : xxxxxxxxx
Up Down Dial
F1 F2 F3
Control:
Call Rel LED
F1 F2 F3
3163-A2-GB20-10
key