Configuring The Dsu/Csu For Snmp Or Telnet Access - Paradyne 3160-A3 Operator's Manual

Procedure
To copy the configuration options to one or all ports:

Configuring the DSU/CSU for SNMP or Telnet Access

To configure the DSU/CSU for SNMP or Telnet access:
T
T
T
T
T
T
T
3160-A2-GB21-90
1. From the Port Select screen, select Copy.
Port Select:
Copy Prt1
F2
F1
2. Select the port from which you want to copy the configuration options using
the corresponding Function key.
Copy From:
Prt1 Prt2
F2
F1
3. Select the port to which you want to copy the configuration options using the
corresponding Function key. Or, press F1 (All) to choose to copy to all ports.
Copy To:
All Prt1
F1 F2
Enable the SNMP agent or Telnet server within the DSU/CSU (see
Appendix C, Configuration Options
Select and configure the port that provides the link to the SNMP or Telnet
system.
Set the Internet Protocol (IP) address and subnet mask needed to access the
Appendix F, IP Network Addressing Scenarios
DSU/CSU (see
Select the link layer protocol (PPP or SLIP) for the port that provides the link to
the SNMP or Telnet system.
For SNMP links, specify the two community names (and their access levels)
that are allowed to access the device's Management Information Base (MIB).
For SNMP links, configure the device to send traps to the SNMP manager, if
desired.
Specify the Telnet password or SNMP validation options, if desired (see
Appendix C, Configuration Options
February 2001
Prt2
F3
Prt3
F3
Prt2
F3
).
).
3. Operation
).
3-19