Table of Contents
Advertisement
Important Instructions
Read and follow all warning notices and instructions marked on the DSU/CSU or
included in this guide.
For a complete listing of the safety instructions, see
at the beginning of this guide.
496-15104
Optional Power Sources
The DSU/CSU is typically powered by the ac power module. Use the
following procedures only if you want to use an optional SELV (Safety Extra
Low Voltage) dc power source.
Using the optional dc power cable, the DSU/CSU is capable of operating on either
a +24 Vdc power source, –48 Vdc single source battery, or –48 Vdc redundant
source batteries (for power backup). To use dc power, choose one of the following
power supply types.
Installing the +24 Vdc Power Supply
To install the DSU/CSU using a +24 Vdc SELV power supply, refer to
+24 Vdc Power Supply
Procedure
To install the +24 Vdc power supply:
3160-A2-GB21-90
!
HANDLING PRECAUTIONS FOR STATIC-SENSITIVE
DEVICES
This product is designed to protect sensitive components from damage
due to electrostatic discharge (ESD) during normal operation. When
performing installation procedures, however, take proper static control
precautions to prevent damage to equipment. If you are not sure of the
proper static control precautions, contact your nearest sales or service
representative.
Pinouts, and use the following procedure.
1. Connect the green wire to a suitable ground.
2. Connect the white wire to the +24 Vdc return.
3. Connect the orange wire to the +24 Vdc source.
4. Cut the black, red, and blue wires off at the outer insulation.
5. Plug the power connector into the DSU/CSU.
February 2001
2. Installation
Important Safety Instructions
Figure 2-9,
2-5
Advertisement
Table of Contents
