Configuring Ds0 Channels - Paradyne 3160-A3 Operator's Manual

Configuring DS0 Channels

The DSU/CSU provides channel configuration options that allow you to do the
following:
T
T
T
T
T
To allocate DS0 channels, begin by defining the logical channel configuration for
the network interface, and then the DTE Drop/Insert (DSX-1) interface, and then
any ports, if desired. See
example of a conceptual diagram of a channel configuration.
Blank configuration worksheets are provided at the back of
Configuration Options
allocation:
Once you have completed the worksheets, enter this information using the
procedures in
3160-A2-GB21-90
Display the DS0 assignments for the network, DTE Drop/Insert (DSX-1), and
data port interfaces.
Allocate DS0 channels on the DTE Drop/Insert (DSX-1) interface to the
network interface.
Allocate DS0 channels on the network or DTE Drop/Insert (DSX-1) interface to
particular data ports.
Clear (deallocate) all DS0 channels from the network, DTE Drop/Insert
(DSX-1), or data port interface.
Map data from one port to another.
Figure 3-6, Example of Channel
. To complete the configuration worksheets for DS0 channel
1. Complete the Network Interface and the DTE Drop/Insert (DSX-1) Interface
tables (unless the DTE Drop/Insert interface is disabled) as shown in the
examples in Figure 3-7, Example of Interface Worksheet for Network
and Figure 3-8, Example of Interface Worksheet for DTE Drop/Insert
2. Complete the Robbed Bit Signaling (RBS) information worksheet as shown in
the examples in Figure 3-9, Example of RBS Information
3. Using the worksheets shown in
Worksheet (Ports 1 and
Worksheet (Ports 3 and
implement the logical channel configuration.
Allocating Data Ports
February 2001
Figure 3-10, Port Channel Configuration
2), and Figure 3-11, Port Channel Configuration
4), circle the configuration options needed to
on page 3-38.
3. Operation
Allocation, for an
Appendix C,
Interface,
Interface.
Worksheet.
3-29