NEC 78K0S/KA1+ User Manual page 148

Cautions 1. Set bits 7, 6, and 5 to 0, 1, and 1, respectively. Do not set the other values.
2. After reset is released, WDTM can be written only once by an 8-bit memory
manipulation instruction. If writing is attempted a second time, an internal reset
signal is generated. However, at the first write, if "1" and "x" are set for WDCS4 and
WDCS3 respectively and the watchdog timer is stopped, then the internal reset
signal does not occur even if the following are executed.
3. WDTM cannot be set by a 1-bit memory manipulation instruction.
4. When using the flash memory self programming by self writing, set the overflow time
for the watchdog timer so that enough everflow time is secured (Example 1-byte
writing: 200
Remarks 1. f
RL
2. f
X
3. ×:
4. Figures in parentheses apply to operation at f
(2) Watchdog timer enable register (WDTE)
Writing ACH to WDTE clears the watchdog timer counter and starts counting again.
This register can be set by an 8-bit memory manipulation instruction.
Reset signal generation sets this register to 9AH.
Figure 9-3. Format of Watchdog Timer Enable Register (WDTE)
Address: FF49H After reset: 9AH
7
Symbol
WDTE
Cautions 1. If a value other than ACH is written to WDTE, an internal reset signal is generated.
2. If a 1-bit memory manipulation instruction is executed for WDTE, an internal reset
signal is generated.
3. The value read from WDTE is 9AH (this differs from the written value (ACH)).
148
CHAPTER 9 WATCHDOG TIMER
• Second write to WDTM
• 1-bit memory manipulation instruction to WDTE
• Writing of a value other than "ACH" to WDTE
µ
s MIN., 1-block deletion: 10 ms MIN.).
: Low-speed internal oscillation clock oscillation frequency
: System clock oscillation frequency
Don't care
R/W
6 5 4
User's Manual U16898EJ3V0UD
= 480 kHz (MAX.), f
RL
3 2 1
= 10 MHz.
X
0