NEC 78K0S/KA1+ User Manual page 198

(c) Normal transmission
When bit 7 (POWER6) of asynchronous serial interface operation mode register 6 (ASIM6) is set to 1, and
then bit 6 (TXE6) of ASIM6 is set to 1, transmission is enabled. Transmission can be started by writing
transmit data to transmit buffer register 6 (TXB6). The start bit, parity bit, and stop bit are automatically
appended to the data.
When transmission is started, the data in TXB6 is transferred to transmit shift register 6 (TXS6). After that,
the data is sequentially output from TXS6 to the T
stop bits set by ASIM6 are appended and a transmission completion interrupt request (INTST6) is generated.
Transmission is stopped until the data to be transmitted next is written to TXB6.
Figure 11-15 shows the timing of the transmission completion interrupt request (INTST6). This interrupt
occurs as soon as the last stop bit has been output.
Figure 11-15. Normal Transmission Completion Interrupt Request Timing
1. Stop bit length: 1
T D6 (output)
X
INTST6
2. Stop bit length: 2
T D6 (output)
X
INTST6
198
CHAPTER 11 SERIAL INTERFACE UART6
Start D0 D1 D2
Start D0 D1 D2
User's Manual U16898EJ3V0UD
D6 pin. When transmission is completed, the parity and
X
Parity
D6 D7
D6 D7 Parity
Stop
Stop