Mounting The Receiver - Bentel Security KYO 320 Installation Manual

122 120
121
129
127
Figure 64 VectorRX-8 Receiver components
120
122
121
127
127
124
Figure 65 VRX32-433 Receiver components
n Mounting the Receiver
When choosing the mounting location ensure that the
mounting surface is flat, as uneven surfaces may impair
proper functioning of the Seize microswitch 124.
Read the following instructions carefully before mount -
ing the Receiver (refer to the Figure 62-64-65).
RED BLK YEL
Figure 63 Connecting the receivers to the Control panel
KYO320
129a 122 120
126 124
120
122
RED BLK YEL GRNGND
125 129
126
GRN YEL2
120
121
ATN1
GND2 GND22
121
127
127
121
Figure 62 VectorRX Receiver components
1. Loosen the screws 126 (it is not necessary to re -
move them).
2. Press down on the tab 128 (126 for VRX32-433 and
VectorRX-8) to release the backplate from the
frontplate.
3. Lift the frontplate upwards to a 90° angle, then pull
the frontplate away from the backplate.
Control Panel
RED BLK YEL
Riceiver 2
APPENDIX
121
NO WIRING
IN THIS
AREA
®
RED BLK YEL GRN
126 129 128 127 126
GRN
120
122
122
GND11 ATN1 GND1
123
123
124
125
121
RED BLK YEL GRN
Riceiver 1
93