Send Message After; Messages; Options; Actions - Bentel Security KYO 320 Installation Manual

+
The ID numbers can be entered in any order. How-
ever, the sequence defined in the Dialler
phonebook will determine the call priority.
n Send Message after ...
This section will allow you to program when the Voice
Message announcement.
Voice on line If this option is enabled, the Voice mes-
sage will be played after detection of a voice response.
If the Control Panel does not detect a voice response
before the Voice timeout ends, it will hang-up and gen-
erate a Dialler action failed event.
Dial If this option is enabled, the Voice message will be
played after Dialling.
Time out If this option is enabled, the Voice message
will be played when the programmed Delay after dial-
ling expires.
+
All calls that comply with the programmed Send
Message After conditions will be considered Suc -
cessful. However, only the Voice on Line option
ensures a proper response to calls, therefore, if
you select Dial or Timeout, you should also enable
Confirm successful calls option.
Voice Timeout This field will allow you to program a
pause after dialling. If the Control Panel does not detect
a voice answer before the Voice timeout ends, it will
hang-up and generate a Dialler action failed event.
+
The Voice Timeout applies to the Voice on Line
option (under Send Message After ...).
Valid entries: 1 through 255 seconds, in 1-second steps
Default setting: 15 seconds
Delay This field will allow you to program a pause be-
tween the end of dialling and the Voice Message an-
nouncement.
+
The Delay applies to the Timeout option
(under Send Message After ...).
Valid entries: 1 through 255 seconds, in
1-second steps
Default settings: 5 seconds
n Messages
The Messages section will allow you to pro -
gram some of the Voice Message parame -
ters.
Message repetitions This field will allow
you to program the number of times the Con -
trol Panel must repeat the Voice Message.
Valid entries: 1 through 99
Default setting: 3
Replay Pause This field will allow you to pro -
gram the pause (in seconds) between Voice
KYO320
Message announcements.
Valid entries: 1 through 10 seconds, in 1-second steps
Default setting: 1 second
n Options
The Options section will allow you to program some of
the Dialler options.
Call successful numbers If this option is enabled, the
Telephone numbers of successful calls WILL BE
REDIALLED in subsequent call cycles. If this option is
disabled (at default), the Telephone numbers of suc -
cessful calls WILL NOT BE REDIALLED in subsequent
call cycles.
+
Events WILL NOT be queued when the Call suc-
cessful numbers option is enabled (refer to
"Events Queue" under "Digital Communicator").
Confirm successful calls If this option is enabled, the
Control Panel will not consider a call successful until
the call receiver presses the star key on the telephone
keypad, in order to generate a feedback signal.
+
If this option is enabled, you should include a re -
quest for the feed back signal (press star) in the
message.
Attempts This field will allow you to program the maxi -
mum number of call attempts the Dialler will make be -
fore aborting the call.
Valid entries: 1 through 99
Default setting: 5
n Actions
Each Dialler Action will trigger a series of telephone
calls (Voice Messages).
The Actions button opens the Actions window, the
layout of which is as follows.
Figure 35 Dialler page
PROGRAMMING 49