Connecting The Receiver; Technical Specifications; B-Net Module; Identification Of Parts - Bentel Security KYO 320 Installation Manual

4. Pull the connection wires through the wire entry
127.
5. Place the backplate in the proposed placement, mark
the screw positions 121 then drill the screw holes.
!
Be careful to avoid conduits and plumbing
when drilling.
6. Place the backplate in the proposed placement, pull
the wires through the wire entry 127, then secure
the backplate to the wall (use anchor screws).
7. Complete the connections on the terminal board
129 (refer to "Connecting the Receiver").
8. Push the frontplate spring catches into the slots on
the backplate then push the bottom of the frontplate
into place.
9. Fasten the screws 126.
n Connecting the Receiver
Connect the Receiver terminal 129 to the Control panel
terminal (as shown in Figure 63).
+
Use Shielded cable for the connection: connect
one end of the shield to terminal BLK on the Inter-
face, and leave the other end free. Do not use more
than 50 metres total wire length.
n Technical Specifications
The following table contains the technical Specifica-
tions of the VectorRX Receiver.
Voltage
Current draw
Frequency
Dimensions (W x H x D)
VectorRX-8 Dimensions
VRX32-433 Dimensions
VectorRX Weight
VRX32-433 Weight
VectorRX-8 Weight

B-NET MODULE

Installing the B-NET Module (Refer to B-NET manual), will
allow you to connect several Control panels to the LAN and
control them from a remote location .
+
The B-NET Module can be enrolled via Keypad only,
and once enrolled ("Present"), the Control panel will
no longer be able to communicate via computer.
n Identification of parts
The following table describes the components shown in
Figure 61. The numbers in boldface used in this section
refer to these components.
94
13.8 V_
50 mA
433 MHz
146 x 290 x 28 mm
135 x 79 x 26
145x105x25
483 g
152 g
90 g
Serrated
flange nut
B-NET backplate
Figure 67 Earthing the B-NET
136
130
135
134
133
130
136
137
Figure 66 B-NET components
To EARTH terminal
of B-NET PCB
Mains earth wire
Screw
136
130
131
132
132
138
130
136